Home > Journals > Minerva Stomatologica > Past Issues > Articles online first > Minerva Stomatologica 2020 Jul 21

CURRENT ISSUE
 

JOURNAL TOOLS

eTOC
To subscribe
Submit an article
Recommend to your librarian
 

ARTICLE TOOLS

Publication history
Reprints
Permissions
Cite this article as

 

 

Minerva Stomatologica 2020 Jul 21

DOI: 10.23736/S0026-4970.20.04354-X

Copyright © 2020 EDIZIONI MINERVA MEDICA

language: English

Effect of photo-polymerization mode on the degree of conversion of resin cement under different ceramic materials

Kamal EBEID 1 , Ahmed SABET 1, 2, Nancy RAFLA 1, Nadin AL-HAJ HUSAIN 3, Mutlu ÖZCAN 4

1 Department of Fixed Prosthodontics, Faculty of Dentistry, Ain Shams University, Cairo, Egypt; 2 Department of Fixed Prosthodontics, British University, Cairo, Egypt; 3 Department of Reconstructive Dentistry and Gerodontology, School od Dental Medicine, University of Bern, Bern, Switzerland; 4 Division of Dental Materials, Center for Dental and Oral Medicine, University of Zürich, Zürich, Switzerland


PDF


BACKGROUND: This study evaluated the effect of different polymerization modes and duration on the degree of conversion (DC) of resin cement under different types of ceramics.
METHODS: Ceramic materials were divided into 3 groups (n=60): Group 1; CERASMART, Group 2; Vita Enamic and Group 3; Vita MARK II. Each group was then divided into three subgroups (n=20) according to the polymerization mode (A; low-intensity, B; high-intensity, and C; soft-start). Subgroups were then divided into two further groups according to the polymerization time (I; 10 s and II; 20 s). DC of light-cured resin cement beneath different kinds of ceramics was tested using FTIR spectroscopy. Results were compared to a control group cured without overlying ceramic.
RESULTS: While the type of ceramic and mode of polymerization showed a significant effect on the DC of resin cement, polymerization duration did not. Vita Mark II group showed significantly the highest DC of resin cement, followed by Vita Enamic and Cerasmart. High and low intensity polymerization modes did not show significant difference but both showed significantly lower DC when compared to soft start mode.
CONCLUSIONS: Type of ceramic and polymerization mode showed a direct effect on the DC of resin cement.


KEY WORDS: Ceramic; Degree of conversion; Feldspathic porcelain; Photo-polymerization; Resin cement

top of page