ORIGINAL ARTICLES   

Minerva Stomatologica 2003 April;52(4):157-68

Copyright © 2003 EDIZIONI MINERVA MEDICA

language: Italian

Bonding compatibility between adhesive systems and composite resins

Giachetti L., Scaminaci Russo D., Landi D.

Aim. The purpose of the present study was to analyse bonding compatibility between photo- and self-polymerising composite resins ad two-step total-etch (one component) adhesive systems with a different activation method.
Methods. Thirty healthy extracted molars were cut transversally to obtain sixty flat dentin surfaces. The acid conditioned surfaces were bonded with Scotchbond 1 (3M), Excite (Vivadent) or Excite DSC (Vivadent). A cylinder of composite resin (3 mm diameter and 4 mm height) was constructed on each adhesive layer using photopolymerised Tetric Ceram (Vivadend) and dual Luxacore (DMG) but activated only chemically. The samples were subjected to the shear bond test. The fracture surfaces obtained were classified by type and site in the stereomicroscope. Twelve samples representing each group were further prepared for the SEM.
Results. The data obtained from the test, the microscopic investigation and statistical analysis (ANOVA and Bonferroni) seem to confirm the presence of a reduced bonding compatibility between one-component adhesive systems and self-polymerising composites. This incompatibility is evident for the adhesive Scotchbond 1 and limited for Excite, while it seems to be overcome by Excite DSC which appears to bond well with both Tetric Ceram and Luxacore.
Conclusions. Adhesive-composite incompatibility seems to depend on the activation method of the composite as well as on that of the adhesive system. The chemical compatibility bet-ween these two materials is influenced not only by the chemical composition of the adhesive, but also by that of the composite.